Category: 1121-22-8

With the rapid development and complex challenges of chemical substances, new drug synthesis pathways are usually the most effective.1121-22-8,trans-Cyclohexane-1,2-diamine,as a common compound, the synthetic route is as follows.

General procedure: A methanolic solution (10mL) of (¡À)-trans-1,2-diaminocyclohexane (dach) (0.23g, 2.0mmol) in a Schlenk tube, was added dropwise to a methanolic solution (20mL) of salicylaldehyde-imidazolium salt H(iPr)sal(Me2Im+-X-) 3a-c (4.0mmol) into a 100mL Schlenk flask under nitrogen atmosphere. The reaction mixture was stirred under N2 at 60C for 3h. Then the solvent was partially removed under reduced pressure, and the yellow products of 4a-c were precipitated by the addition of ethyl acetate and kept in the refrigerator overnight. Solvent was decanted off and the obtained crude product was sonicated for 15min in Et2O (3¡Á25mL). Et2O was also decanted off and the residual solid was washed intensively with MeOH/Et2O mixture (1:2) to remove unreacted materials and then re-dissolved in MeOH. EtOAc was added slowly (?15min) to precipitate the products as pale yellow-dark orange solids which were collected by filtration and dried under vacuum. Samples of the isolated solids were characterized as follows.

The synthetic route of 1121-22-8 has been constantly updated, and we look forward to future research findings.

Reference£º
Article; Elshaarawy, Reda F.M.; Kheiralla, Zeinab H.; Rushdy, Abeer A.; Janiak, Christoph; Inorganica Chimica Acta; vol. 421; (2014); p. 110 – 122;,
Chiral Catalysts
Chiral catalysts – SlideShare

With the rapid development and complex challenges of chemical substances, new drug synthesis pathways are usually the most effective.1121-22-8,trans-Cyclohexane-1,2-diamine,as a common compound, the synthetic route is as follows.

Into a solution containing 1,6-diisocyanatohexane (4.03 grams, 24 mmol; obtained from Sigma-Aldrich Fine Chemicals) and a 1:1 mixture of hexane and tetrahydrofuran (100 milliliters) stirring at room temperature was added a solution containing triethylene glycol monomethacrylate (5.24 grams, 24 mmol; obtained as CD570 from Sartomer Company Inc., Exton, Pa.) dissolved in a 1:1 mixture of hexane and tetrahydrofuran (10 milliliters) and dibutyltin dilaurate (0.075 grams, 0.12 mmol (obtained from Sigma-Aldrich Fine Chemicals) as the catalyst. The mixture was stirred and heated to an internal temperature of 40 C. The progress of the reaction was monitored by 1H-NMR spectroscopy for consumption of the triethylene glycol monomethacrylate reactant. The mixture was cooled to about 15 C. temperature, after which to this mixture was added dropwise a solution of trans-1,2-diaminocyclohexane (1.37 grams, 12 mmol; obtained as a racemic mixture of (1R,2R) and (1S,2S) stereoisomers from Sigma-Aldrich Fine Chemicals) dissolved in a 1:1 mixture of hexane and tetrahydrofuran (10 milliliters). The reaction mixture was stirred for 1 hour while warming up to room temperature. FTIR spectroscopic analysis of a reaction sample showed little unreacted isocyanate (peak at 2180 cm-1, sample prepared as a KBr pellet). Any residual isocyanate reagent was quenched by addition of methanol (5 milliliters). The reaction mixture was then filtered by vacuum filtration to give 6.13 grams of a solid product as a white powder (58 percent yield). 1H-NMR spectroscopic analysis of the solid was performed in DMSO-d6 (300 MHz) at room temperature (25 C.) and exhibited spectral assignments that matched those found for the compound in Example XVIII. The product was believed to be of the formulae

The synthetic route of 1121-22-8 has been constantly updated, and we look forward to future research findings.

Reference£º
Patent; Xerox Corporation; US2006/122415; (2006); A1;,
Chiral Catalysts
Chiral catalysts – SlideShare

1121-22-8, trans-Cyclohexane-1,2-diamine is a chiral-catalyst compound, ?involved in a variety of chemical synthesis. Rlated chemical reaction is continuously updated

To a solution containing 1,6-diisocyanatohexane (5.04 grams, 30 mmol; obtained from Sigma-Aldrich Fine Chemicals, Milwaukee, Wis.) and anhydrous tetrahydrofuran (100 milliliters) stirring at room temperature was added 1,4-butanediol vinyl ether (3.48 grams, 30 mmol; obtained from Sigma-Aldrich Fine Chemicals) and dibutyltin dilaurate (0.19 grams, 0.3 mmol; obtained from Sigma-Aldrich Fine Chemicals) as the catalyst. The mixture was stirred and heated to an internal temperature of about 65 C. for 25 minutes. The progress of the reaction was monitored by 1H-NMR spectroscopy for consumption of the 1,4-butanediol vinyl ether reactant, indicated by the disappearance of the -CH2OH multiplet, which appears at 3.5 ppm as a shoulder peak on the downfield end of the intermediate isocyanate product whose signal is located at 3.35-3.40 ppm. The mixture was cooled to about 15 C. internal temperature after which to this mixture was added dropwise a solution of trans-1,2-diaminocyclohexane (1.71 grams, 15 mmol; obtained as a racemic mixture of (1R,2R) and (1S,2S) stereoisomers from Sigma-Aldrich Fine Chemicals) dissolved in anhydrous tetrahydrofuran (10 milliliters). The mixture was stirred for about 60 minutes while warming up to room temperature, and thickened to form a gelatinous slurry. FTIR spectroscopic analysis of a reaction sample showed little unreacted isocyanate (peak at 2180 cm-1, sample prepared as a KBr pellet). Any residual isocyanate was quenched by addition of methanol (5 milliliters). The reaction mixture was then filtered by vacuum filtration to give a semi-solid product, which was subsequently stirred in hexane to ensure full precipitation. The solid product was filtered and dried in air to give 8.17 grams of a white powder (79 percent yield). The product was believed to be of the formulae 1H-NMR spectroscopic analysis of the solid was performed in DMSO-d6 (300 mHz) at high temperature (60 C.) and indicated the above structure with the following assigned peaks: 1.05-1.90 ppm (several multiplets, 16 H integration, 4 methylene protons from 1,4-butanediol vinyl ether portion, 8 methylene protons from the 1,6-diisocyanatohexane portion, and 4 methylene protons from the cyclohexane ring portion); 2.95 ppm (multiplet, 4 H integration, -NH(CO)NHCH2(CH2)4CH2NH(CO)O-); 3.2 ppm (broad singlet, 1 H integration, tertiary methane proton adjacent to urea group on cyclohexane ring); 3.70 ppm (multiplet, 2 H integration, NH(CO)O(CH2)4-O-C(Hc)C(Ha)(Hb)); 3.96 ppm (doublet, 1 H integration, -O-C(Hc)C(Ha)(Hb)); 3.98 ppm (multiplet, 2 H integration, NH(CO)OCH2CH2CH2CH2-O-C(Hc)C(Ha)(Hb)); 4.20 ppm (doublet, 1 H integration, -O-C(Hc)C(Ha)(Hb)); 5.60 ppm and 5.72 ppm (broad singlets, each 1 H integration, urea NH protons); 6.48 ppm (doublet of doublets, 1 H integration, -O-C(Hc)C(Ha)(Hb)); 6.82 ppm (broad singlet, 1 H integration, urethane NH proton). Elemental analysis calculated for C: 59.80%, H: 9.15%, N: 12.31%; found for C: 59.36%, H: 9.53%, N: 12.58%.

As the paragraph descriping shows that 1121-22-8 is playing an increasingly important role.

Reference£º
Patent; Xerox Corporation; US2006/122415; (2006); A1;,
Chiral Catalysts
Chiral catalysts – SlideShare

With the rapid development and complex challenges of chemical substances, new drug synthesis pathways are usually the most effective.1121-22-8,trans-Cyclohexane-1,2-diamine,as a common compound, the synthetic route is as follows.

A methanolic solution of ligand trans-cyclohexane-1,2-diamine(0.1142 g, 1 mmol) was added dropwise to a clear solution ofCopper(II) trifluoromethanesulfonate (0.1808 g, 0.5 mmol) inmethanol (10 mL). The resultant solution was stirred at roomtemperature for 6 h to produce a dark blue coloured solution. Thediffraction quality crystals of the titled complex were obtaineddirectly by slow evaporation of the deep bluish methanolic solutionat room temperature. Yield: 0.272 g, 75%, m.p: 258 C, Anal. Calc. forC14H32CuF6N4O8S2: C, 26.86; H, 5.15; N, 8.95. Found: C, 26.54; H,5.32, N, 8.78. Selected FT-IR (KBr), cm1: n(NH2) 3332e3279, n(CH2)2967e2861, n(OH) 3463, n(CueN) 628, n(CueO) 514. UVeVis [lmax(nm), epsilon (L mol1 cm1)]: 243 (8940), 548 (89).

1121-22-8 trans-Cyclohexane-1,2-diamine 43806, achiral-catalyst compound, is more and more widely used in various.

Reference£º
Article; Agrahari, Bhumika; Layek, Samaresh; Kumari, Shweta; Anuradha; Ganguly, Rakesh; Pathak, Devendra D.; Journal of Molecular Structure; vol. 1134; (2017); p. 85 – 90;,
Chiral Catalysts
Chiral catalysts – SlideShare